These rubber end stops are perfect for use with linear rails. By placing them on the end of the rail, you can prevent the carriage from running too far. They work well with limit switches as an additional measure of protection.

The SBR Linear motion ball slides allow you to move along SBR Supported Rods. They have a platform with four holes tapped for M5 screws, providing a perfect mounting point for any mechanism you require to move in a linear direction.

With these low-profile self-tapping screws, you can easily build a boxed frame out of V-Slot corner connectors. You'll have your frame built in minutes! No more need for tapping - these screws make it quick and easy.

Looking for an easy way to extend the distance between your servos and control boards? Check out our 1000mm servo extension cable! It has JR male and female end connections, making it a quick and simple solution.

Looking for a reliable and sturdy shaft collar? Our set screw-type shaft collar is perfect for ACME threaded rods or smooth shafts. Available size is 8mm ID and 14mm OD.

This cable is versatile and can be used with our Inductive Proximity Switches or for any applications that require a stronger current. The shielding protects against Electro-Magnetic Interference (EMI) and false triggers. Note: Sold by the meter. If you order 5 meters, you will receive one 5-meter length.

This cable is compatible with NEMA23 stepper motors. The shielding reduces signal noise and helps eliminate lost steps, providing smoother and more precise motion for your stepper motor. Note: Sold by the meter. If you order 5 meters, you will receive one 5-meter length.

This cable is designed to be used with our high-powered 3.0Nm NEMA23 stepper motors and Closed Loop stepper motors. The shielding reduces the effects of Electro-Magnetic Interference (EMI) and helps eliminate lost steps. Note: Sold by the meter. If you order 5 meters you will receive one 5-meter length.

Looking for a sturdier, more reliable T-Nut for your next project? Our Sliding T-Nut is perfect for all V-Slot aluminum extrusions. The extra thickness allows for greater screw-to-thread contact and a tighter, firmer fastening.

Dress up your v-slot machinery frame with these awesome snap-in slot covers! They're the perfect finishing touch for any build. Choose your favorite color and add a touch of personality to your machinery.

This pulley is designed to work with 6mm wide GT2 2mm pitch timing belts. It's a perfect match for GT2 pulley-belt sets. The idler is also a good choice for 20T GT2 timing belt pulleys driven by stepper motors.

This 10mm smooth rod rail is a steel component that's used to support and guide the movement and used as a linear rail along with our linear bearings.